AGL GradeLight 3000, Руководство пользователя

Страница: 29 / 40

28
MENU OPTIONS
The user and service personnel can access information through the Set Up Mode. These are
the menu selections shown in Step 3 in the next section:
INFO Shows serial number, software version, number of working hours, and
service information. There are no values that can be changed.
SETTINGS Three settings can be changed; see instruction later in this section.
·
The service interval reminder (CHECK CAL) can be changed from the
default of 2000 hrs. to 500 or 1000 hrs.
·
When the reminder appears on the screen, it can be turned off (and the
counter reset to 0 hours).
·
The start-u screen can be changed from “AGL” to your company
information.
CALIBRATION
See instructions for “Adjusting Level Accuracy” later in the manual.
SERVICE
A password is needed by service personnel to access this area.
Entering the Set Up Menu
Turn the laser off, and then turn the laser on again.
When the “AGL” or company information start-up
screen is displayed, press the
+ and ENT buttons
simultaneously. Hold until the Set Up screen appears
(after the Battery Check).
The cursor and highlighted text indicate the active
menu step.
Use the + or – buttons to move up or down the menu.
When you reach the desired step, such as
CALIBRATION, press
ENT .
When you want to leave a menu section, move the
cursor to
EXIT and press ENT .
Changing the Service Interval
The interval for the Service Reminder can be changed from the default of 2000 working hours
to 500 or 1000 working hours.
1. Enter the Set Up Mode following Steps 1-3 of “Set Up Menu” in previous section.
2. Move down the menu to SETTINGS and press ENT.
3. Go to CAL CHECK TIME and press ENT.
4. In this menu, select 500, 1000, or 2000 hours. The time currently selected will say
CAL TIME = XXXX HRS.
5. Use the + or – buttons to select the desired time and press ENT.
6. Move down to EXIT and press ENT. Repeat to leave the Set Up Menu.