To Automatically Center the Beam
On laser keypad, press simultaneously &
On remote, press
Replacing the Batteries of the Remote Control
The LED on the remote will flash red when the batteries are low. To change the batteries:
1. Open the housing by removing the 6 screws.
2. Take the back case off and replace the
batteries, matching the polarity indications.
Use AA alkaline batteries of the same type;
do not mix new and old batteries, as their
lifetime will decrease.
3. Before closing, check that the seal is free of
dirt, to ensure it remains waterproof.
4. Close the housing and tighten the 6 screws
so it’s watertight.
Adjustable Leg Set
One leg set covers multiple pipe sizes. The adjustable “slide leg system” allows the user to set
centerline in 8”, 10” and 12” pipe (200, 250, and 300mm with the metric leg set). The legs can
also be adjusted to non-standard heights.
The three-leg design provides stability when setting up on uneven, rough surfaces.
To attach legs:
1. Use curved centerline leg at rear (keypad end) and
two side legs at front.
2. Slide each leg into the slot on the housing.
3. Match the red reference marks on the housing to red
mark on leg. There are 3 reference marks: 8”, 10”, and 12”
(200, 250, and 300mm).
4. Tighten front legs with thumb screws, and single leg
with toggle screw.
Note: The legs will then be aligned for use in a pipe’s curved surface, where the two side legs
need to be shorter than the center leg. If you are setting up on a flat surface, adjust the legs
differently to level the unit.
For 6” pipe (150mm), use the unit’s built-in feet. A long leg set is available as an optional acces-
sory for 15” to 24” pipe (with a metric leg set for 375 to 600mm pipe).
8
