Remote Control Overview
The remote is used primarily to move the beam left or right, within the azimuth range, and
to put the laser in standby or locked modes. Since it’s an infrared line-of-sight device, there
should be no obstructions between it and the laser. It can be pointed at either the front side
(through the pipe) or the back side of the laser.
Remote Keypad Functions
Standby Mode
• Press and hold 2 seconds. This puts laser in standby mode to save
battery life during breaks. LCD on laser will show sleep symbol.
• Press again to return to normal operation. All settings are retained.
Reset Line to Center
Hold 2 seconds, and laser beam automatically moves back to center
azimuth position.
Line Adjustment
(left and right azimuth control)
When using remote from the target side, beam moves in the direction
of the arrows. If using remote from laser keypad side, beam moves in
the opposite direction.
Activates Lock Function
All buttons on the remote and laser are blocked, preventing uninten-
tional changes when the laser is in use. LCD on laser shows a lock
symbol. To deactivate: Press the lock button again.
LED for Line Pivot Point
Press to turn on LED on top of laser, which is used for alignment out-
side of the manhole. Automatic shut-off after 1 minute.
Line Adjustment
The laser beam can be aligned to the target using the left and right line adjustment. The
azimuth indicator on the LCD shows the beam position in the adjustment range. Before each
setup, center the beam to allow maximum adjustment in each direction. The total range of
movement is 20’ at 100’ (6m at 30m).
To Move the Beam
Use arrows on the laser keypad or remote. Movement will start slow and speed up as long as
the button is pressed.
7
Compartment for
3 AA batteries
(back side)
Infrared output:
aim at capture
window of laser
LED flashes when any
button is pressed.
-- Green: normal
-- Red: low remote battery
