Agilent Technologies G1369C, Руководство пользователя, Страница: 32 / 66

32 G1369C LAN Interface User Manual
2 Getting Started
Automatic Configuration with Bootp
Configuring the CAG Bootp Server Program
1 The CAG Bootp Server program is placed in the start- up group and
automatically is started during the boot process of the PC. It’s
minimized and located in the task bar.
2 Open the Bootp Server window by clicking on it in the task bar.
3 Now turn on the module with the LAN Interface Card and view the
Bootp Server window. After some time the Bootp Server will display the
request from the LAN Interface Card with the hardware (MAC) address
(this information is also stored in the file trace.txt in the bootp server
directory, if Log to Disk is enabled), see
Figure 20 on page 33.
The MAC or hardware address of the LAN Interface Card is a world
wide unique identifier. No other network device will have the same
hardware address.
N O T E
When using this Bootp mode, the parameters are not written into the non-volatile memory
of the detector. If you delete this Bootp Configuration, the Bootp Manager will show up as
shown in
Figure 17 on page 29 ( Bootp mode).
If you want to store your parameters permanently on the detector (for use without the
Agilent Bootp service), refer to
“Storing the Settings Permanently with Bootp Program” on
page 37.
N O T E
All examples shown in this chapter will not work in your environment.
You need your own IP- , Subnet- Mask- and Gateway addresses.
N O T E
Assure that the LAN Interface Card configuration switch is set properly.
The setting should be either
Bootp or Bootp & Store, see Table 5 on
page 22.
N O T E
Assure that the instrument with the LAN Interface Card installed and connected to the PC
is powered off.
N O T E
If the CAG Bootp Server program is not already installed on your PC, then install it from your
Agilent ChemStation CD-ROM, located in folder \Bootp.