Agilent Technologies 1200 series, Справочное руководство

Страница: 163 / 278

Agilent 1200 Series Autosampler Reference Manual 163
Repairing the Autosampler 4
To change the product number go to the
System
screen.
1
Press Tests (F3) and select the module being changed and press Enter .
2
While in the Tests screen, press m.m (m dot m).
3
From the box now displayed, select the Command , and press Enter .
4
Into the box labeled Instr (instruction), enter the command
TYPE XXXXX
.
Letters and numbers are created using the up and down arrows. XXXXX is
the 5-character product number of the module being changed. There must
be a space between the word TYPE and the product number.
Examples:
TYPE G1329A
to configure as a standard autosampler.
TYPE G2260A to configure as a preparative autosampler.
When the command is entered, press Enter to highlight the complete command.
5 Now, press the Execute key. Below the box, a reply line should then say:
Reply RA 0000 TYPE "XXXXX" (XXXXX is what you just entered)
6
Turn the module off, then on again. Turn on should be normal. In the
Records screen, the product# column should indicate the module you just
entered. If an Agilent ChemStation is also connected, re-boot it now.
Entering the Serial Number using the Control Module
1
Connect the control module to the autosampler. Turn ON the autosampler.
2
In the control module, press
System
(
F5
), then
Records
(
F4
). Using the
up/down arrows, make sure that the autosampler is highlighted.
3
Press
FW Update
( F5 ). Now, press m . This will display a box which says
‘
Update Enter Serial#
’.
4
Press Enter . This will display the box labeled
Serial#
.
5
Letters and numbers are created using the up and down arrows. Into the
box labeled
Serial#,
enter the 10-character serial number for the
WA R N I N G
If you enter the wrong type, your module might not be accessible anymore with
the Agilent ChemStation. In such a case re-enter the TYPE command correctly.