AGI WESTFIELD 1500 Series, Руководство оператора

Страница: 39 / 74

P1512137 R3 39
Figure 12. Typical Extendable Axle
5.4. Positioning the Conveyor with a Wheel Move Kit
Æ
When equipped with a Wheel Move Kit:
Before Operating the Wheel Move Kit:
• Ensure the area around the conveyor is reasonably level and there is adequate clearance for making wide
turns.
• Check the hydraulic oil to ensure that the levels are correct.
Running the machine on low oil will overheat the system causing components to break
down.
To Operate the Wheel Move Kit:
1. Engage the over-center handle at each wheel ( Figure 13 on page 39 ) and check that the gears are fully
meshed. If necessary, refer to Pinion Gear Adjustment section.
Figure 13. Wheel Over-Center Handle Positions
Engaged Disengaged
2. Set and run the gas engine at approximately half throttle.
3. Refer to the controls shown in Figure 14 .
4. Before moving the conveyor into position:
S-DRIVE STANDARD CONVEYOR – PORTABLE GRAIN BELT CONVEYOR 5. PLACEMENT