40
P1512137 R3
•
Fully lower the conveyor.
•
Raise the intake end slightly off the ground to position the conveyor.
•
Raise the conveyor discharge end only for final positioning such as when next to a storage bin or grain
truck.
Figure 14.
Wheel Move Kit Controls
1
4
3
2
4
2
3
1
If Operating the Wheel Move Kit in Temperatures Below -10°C (14°F):
• Disengage the pump when starting the motor cold. This will put less pressure on the starter and allow the
motor to turn over easier, helping it to start.
• Allow the hydraulic oil to warm before using the self-propelled kit.
Failure to warm the hydraulic oil can damage the pump or other components.
When Operation of the Wheel Move Kit is Complete:
1. Secure the wheel move kit axle to the conveyor when operation is complete or before transporting.
2. Fully disengage the over-center handles and secure the handle with the attached pin, see
.
S-DRIVE STANDARD CONVEYOR – PORTABLE GRAIN BELT CONVEYOR
