38
P1512137 R3
Figure 11.
Typical Grain Conveyor Placement for Filling Bins
KEEP AWAY!
OVERHEAD WIRES
wheel chocks
Under Hopper Bottom Bins
1. Center the conveyor between the hopper bin’s vertical legs.
2. Collapse the cloth hopper until the conveyor is fully positioned under the bin.
3. Move the conveyor into place. Do not allow the conveyor tube or components to contact the bin.
4. Raise the conveyor to the desired height.
5. Make sure that gravel is not jammed against the belt under the hopper.
6. Place chocks in the front and back of each wheel and anchor the intake end.
5.3. Extendable Axle Positioning
Æ
When equipped with extendable axles:
Important
Do not raise the conveyor unless the axles are in the extended position. Do not transport the conveyor
unless the axles are in the retracted position.
Rollover can occur if axles are not extended before raising the conveyor.
1. Ensure the conveyor is on level ground before attempting to extend or retract the axles.
The conveyor must
be attached to tractor at all times.
2. Using the jack supplied, insert it into one of the jack stubs located on one end of the axle. Jack must be
secured to jack stub using pin (attached to jack).
3. Raise one side at a time. Raise until the tire clears the ground.
4. Remove the axle pin from the axle and position the axle as desired until the holes line up. Reinsert the axle
pin and secure with hairpin. Lower the jack.
5. Repeat the process on the opposite side of the axle.
S-DRIVE STANDARD CONVEYOR – PORTABLE GRAIN BELT CONVEYOR