AGI Batco 1500 SA Series, Руководство оператора

Страница: 72 / 76

72 8210–00011 R1
The transmitter automatically transmits a STOP signal after 30 minutes; this de-activates the
receiver and the transmitter keypad.
The remote transmitter that comes with each power swing is normally factory programmed to
function with the power swing receiver. Refer to specific instructions for programming
additional or replacement remotes according to the serial number of the power swing receiver.
10.2. Programming Receivers
Turn on all the remote transmitters before programming.
Note
To de-register all remote transmitters from the receiver, hold down the OFF button on a remote for at
least 60 seconds.
TO REGISTER THE FIRST REMOTE TRANSMITTER:
1. Switch OFF the receiver.
Important
Steps 2 and 3 must be done within 10 seconds of each other. The FAULT LED on the receiver flashes
for the duration of the registration window.
2. Switch ON the receiver.
3. On the first remote, press the ON button and the yellow Down-Arrow Motion button at the same time and
hold until the red light on the receiver SET LED illuminates solid red. Release buttons. The remote is
programmed, and should be set aside.
TO REGISTER A SECOND REMOTE TRANSMITTER:
1. Switch OFF the receiver.
Important
Steps 2 and 3 must be done within 10 seconds of each other. The FAULT LED on the receiver flashes
for the duration of the registration window.
2. Switch ON the receiver.
3. On a 2nd remote, press and release the ON button once, then press the ON button and the Down-Arrow
Motion button at the same time and hold until the red light on the receiver SET LED illuminates solid red.
Release buttons. The remote is programmed, and should be set aside.
TO REGISTER A THIRD REMOTE TRANSMITTER:
1. Switch OFF the receiver.
Important
Steps 2 and 3 must be done within 10 seconds of each other. The FAULT LED on the receiver flashes
for the duration of the registration window.
2. Switch ON the receiver.
3. On a 3rd remote, press and release the ON button twice, then press the ON button and the Down-Arrow
Motion button at the same time and hold until the red light on the receiver SET LED illuminates solid red.
Release buttons. The remote is programmed, and should be set aside.
10. APPENDIX SWING-AWAY CONVEYOR – PORTABLE GRAIN BELT CONVEYOR