AFP Imaging Mini-Medical Series, Инструкция по установке, эксплуатации и сервисному обслуживанию

Страница: 61 / 132

Maintenance
Mini Med Series 0000061122
Monthly Cleaning
As film is processed, by-products are released into the developer, fix and wash systems.
These must be removed by regular cleaning. Every month, schedule two hours of processor
downtime to thoroughly clean the developer, fixer and wash systems.
NOTE: This cleaning will replace the scheduled Weekly Cleaning due on the same date.
1) Open the drain valves, drain and dispose of the used developer, fixer and wash water.
Allow the tanks and recirculation systems to drain completely.
Caution: When filling or rinsing the processor tanks, use water no hotter than 120
degrees F (54 degrees C).
2) Bring a small bucket or container of warm water to the processor and place the red and
blue intake hoses going to the replenisher pumps into the container. Press and hold the
manual replenishment switch (located on the upper right hand front corner of the machine)
until the water comes out clear. Remove the intake hoses from the container and press and
hold the switch again until the pumps and lines are purged. Replace the hoses to their
original chemistry containers.
3) Rinse out each tank and then close the drain valves and fill the wash tank with warm
water.
4) Systems Cleaning.
The use of Developer Systems and Fixer Systems Cleaners are recommended for cleaning
the developer and fixer system. Carefully follow the manufacturer’s instructions and pre-
cautions. Dissolve any powdered chemicals in water before adding to the tank. Be sure to
accomplish the neutralizing and rinsing steps recommended by the systems cleaner manu-
facturer.
WARNING: Beware of all rotating gears, shafts and drive belts when operating the
processor with its access panels removed.
5) After the developer and fixer systems are thoroughly cleaned, neutralized and rinsed, fill
each tank with fresh warm water and install the racks. Switch processor ON and allow the
transport and recirculation systems to run for about 15 minutes as a final rinse.
(Continued on Next Page)
4-5