AFP Imaging Mini-Medical Series, Инструкция по установке, эксплуатации и сервисному обслуживанию

Страница: 32 / 132

Installation
Mini Med Series 0000061122
Dimensions
Mini-Medical Processors occupy 8.0 square feet (22.5" X 24") (57 X 61 cm.) of floor or
counter space. The processor should be positioned to allow easy access to all sides of the
unit for routine cleaning and preventive maintenance. Drain tubes, leading out of the “front”
of the processor, below the feed tray, must be readily accessible.
Weight
The Mini-Medical Processors weigh approx. 110 lbs. when empty, and approximately 160
lbs. when operating.
To support this weight a Processor Stand Assembly is included. Instructions for the assem-
bly of this stand can be found in Section 7, Accessories. If the stand is not used, a sturdy,
stable and level stand, table or counter must be provided.
Ventilation
WARNING: Some processing chemical fumes may irritate eyes and/or respiratory systems
when used in a poorly ventilated area. If the processor is to operate in a confined area,
provide for at least ten complete changes of air per hour.
Provide adequate ventilation for proper machine operation and operator comfort. The pro-
cessor generates a moderate amount of heat when operating and must not be placed in a
confined space, such as a closet.
For best processing results, relative humldity should be between 40% and 60%.
Electrical
Electrical connections must include a ground and conform to local codes. The processor
plugs into a standard 120 VAC, 60 Hz, 15 amp., 3 wire outlet. As a factory installed option,
Mini-Medical Processors may also be configured for 230 VAC, 50 Hz, operation.
Through-the-Wall
Installation
If your processor is to be Installed through the darkroom wall, refer to Section 7, pages 6
and 7.
2-2