AFP Imaging Mini-Medical Series, Инструкция по установке, эксплуатации и сервисному обслуживанию

Страница: 35 / 132

Installation
Mini Med Series 0000061122
Replenish Mode
In “Replenish” mode, fresh replenisher will be pumped from the replenisher supply to the
processing tank. Excessive chemicals in the processing tank will flow out of the tank at an
overflow port and into either a container for disposal or an appropriate drain line. In this
manner, constant processing chemical strength may be maintained for longer periods of
operation.
To install the processor for “Replenish” mode replenishment operation proceed as follows:
(See Figure 2-2)
1) Attach the red developer replenisher pickup tube from the developer replenisher pump
to the developer replenisher reservoir fitting.
2) Route the red developer drain line and red overflow line from the processor to an over-
flow container or drain line.
3) Attach the blue fixer replenisher pickup tube from the fixer replenisher pump to the fixer
replenishment reservior fitting.
4) Route the blue fixer developer drain line and blue overflow line from the processor to the
overflow container or drain line.
Figure 2-2, Replenish Mode Operation
2-5
DEV
FIX
To Repl. Pump (s)
To Drain