Load the printed roll and move it against
the roll guide. Tighten the core holder.
Load the lamination roll, move it along
the supply shaft and make it match with
the web.
IMPORTANT: the lamination roll always
needs to be narrower than the web width.
Example: if the web width is 7” then the lamination roll
needs to be lesser than 7” (let’s say ¼ inch on each end).
At this point you can tighten the core
holder.
When the LEDs on the control board
are off, the device works on a manual
feeding.
Move the media through the rollers and
press the FORWARD button. The media
will be loaded through the rollers whereas
if you push the BACKWARD button, the
rollers will roll the media backwards.
6
Load an empty cardboard core onto
the shaft intended for laminate liner
rewinding. Tighten the core holder.
Core Holder No. 1 intended for laminate
use
Core Holder No. 2 intended for laminate
liner use
Core Holder No. 3 intended for printed roll
use
1
2
3
