Afag PDZ-128, Перевод оригинальной инструкции по монтажу

Страница: 50 / 58

50 PDZ-128-160-200 OI-vers. 3.2 gb. 03.07.2018
Faults during operation
Fault Possible cause Fault clearance
Cantilever oscillates
(very strong vibrations
at the drive Wrong setting of control
parameters Reset parameters at the
control system
Cantilever stops after a
short stroke Important contouring error Reduce values for
acceleration and speed
Check whether cantilever is
mechanically blocked
Resolver connection
interrupted Check encoder cable
Check encoder for proper
functioning. Carry out
functional test according to
chapter "Start-up"
Increased toothed belt
noise Wrong toothed belt
tension Check toothed belt tension
and tension again according
to the instructions if
necessary
Normal operation noise
due to material
combination of
polyurethane and steel Apply slide or silicon spray
to the toothed belt, as
described
Toothed belt defective Replace defective toothed
belt according to the
instructions
Increased running noise
on the cantilever-axis Insufficient lubrication of
the linear guide Lubricate guides according
to the instructions
Appreciable play in the
linear guides Have guide replaced by
Afag AG
Ball bearing of the primary
shaft or deflection pulleys
defective Have ball bearings replaced
by Afag AG
Gear defective Replace gear