28
The main sprogs for Profi TL should be set to 11 deg.
The outer sprogs for Profi TL should be set to 14 deg.
Figure 66
To adjust the sprog angle:
1. Using the wrench as shown on fig. 66
unlock the sprog threaded adjuster.
2. Remove the pin from the sprog threaded
adjuster at the front of the sprog. To raise the
sprog turn the end of the sprog threaded
adjuster counter clockwise. To lower the
sprog turn the end of the sprog threaded
adjuster clockwise.
3. Re-install the pin to the sprog threaded adjuster, install a safety ring and lock the adjuster
with a nut. Press down firmly on the rear end of the sprog to seat the cable before checking the
measurement again.
4. Using the wrench as shown on fig. 48 lock the sprog threaded adjuster in place.
11. SAIL REMOVAL
Some maintenance and repair procedures will require the removal of the sail from the frame.
Please follow these instructions when removing and reinstalling the sail. Please read all the
instructions for each operation before beginning.
You will need an unobstructed area 2m by 9m. Make sure the surface is clean. If it is abrasive,
you should either put down a protective tarp or be extremely careful not to scrape your sail.
11.1. Unzip the wing bag.
11.2. Set the wing on the A-frame. Remove the wing bag, protective bags and pads.
Figure 67
Figure 68
11.3. Spread out the wings slightly, approx. 20% from the fully closed position (fig. 67).
11.4. Remove the number 1 battens and the nose battens from the sail.
