8
3.4. Turn the wing on one side and spread the control frame down tubes. Install the control bar
according to the markings. Fix the control bar with bolts and nuts so, that fixing nuts are
pointing backwards, against the direction of flight (fig.6).
Figure 6
Figure 7
3.5. Lift the wing upright on its control frame (fig.7). Try to set the control bar on level ground.
Do not attach the front wires for now.
3.6. By lifting up and back of the nose batten strings, push the nose battens fully back into the
sail so that the batten tips rest in the holes on top of the keel tube (fig. 8).
Figure 8
Figure 9
3.7. Remove protection bags from the keel, from the control frame apex, from the hang bracket
and from the crossbar central unit.
3.8. Pay attention to the control frame / keel tube junction, making sure it does not stay out of
alignment (fig. 9).
3.9. Remove all Velcro ties and spread the wings approximately 30% from fully open.
3.10. Lay the struts on the ground as shown on the figure 10. Attach the struts according to the
markings. L-left, R-right marks must be on the control frame side of the struts, on top. Attach
the lower part of the strut to the control frame bracket using the pin and the safety ring (fig. 11).
Do not attach the strut safety wire to the base tube for now.
