9
Figure 10
Figure 11
Figure 12
3.11. Lift the upper part of the strut and attach
it to the crossbar junction. Attach the strut
safety wire. It may be necessary to push the
wing forward to be able to fair the holes when
attaching the strut. Tighten the nut and secure
with a safety ring (fig. 12). Repeat procedure
for the other side of the wing.
Figure 13
3.12. Attach the bottom front wires and
secure the nose catch of the bottom wires on
the nose junction channel using the clevis
pin and the safety ring (fig. 13).
3.13. Check that the sail mount webbing is in proper position in the slot of the outer leading
edge tube end cap. Open the main sprog access zipper and look inside, making sure that the
leading edge #3 stays in place and the triangular markings on the leading edge tube #3 and on
the leading edge tube #2 match together.
3.14. Carefully spread the wings all the way, lowering the nose of the wing on the ground (fig.
14). Once the nose of the wing is on the ground the wings spread themselves. You will need an
assistant to perform this procedure.
