Aerohive HiveAP 20, Руководство по развертыванию

Страница: 66 / 80

Deployment Guide 65
R
ACK
M
OUNTING THE
H
IVE
M
ANAGER
R
ACK
M
OUNTING THE
H
IVE
M
ANAGER
You can mount the HiveManager in a standard 19" (48 cm) equipment rack with two rack screws — typically 3/4",
1/2", or 3/8" long with 10-32 threads. The HiveManager ships with mounting brackets already attached to its left
and right sides near the front panel (see
Figure 1 on page 62 ). In this position, you can front mount the HiveManager
as shown in Figure 5 . Depending on the layout of your equipment rack, you might need to mount the HiveManager in
reverse. To do that, move the brackets to the left and right sides near the rear before mounting it.
Figure 5 Mounting the HiveManager in an Equipment Rack
1. Position the HiveManager so that the holes in the mounting brackets align with two mounting holes in the
equipment rack rails.
2. Insert a screw through a washer, the hole in one of the mounting brackets, and a hole in the rail.
3. Tighten the screw until it is secure.
4. Repeat steps 2 and 3 to secure the other side of the HiveManager to the rack.
Washer Rack
Screw
Mounting
Bracket
Rack Rails