Aerohive HiveAP 20, Руководство по развертыванию

Страница: 41 / 80

Chapter 3 The HiveAP 28 Outdoor Platform
40 Aerohive
Strand Mount
The HiveAP 28 outdoor platform can also be mounted on a cable or strand of wire as shown in Figure 6 . When
mounted on a wire strand, use 90-degree N type adapters (not included) to orient the antennas vertically. If you do
not use the adapters and orient the antennas horizontally, the area covered will be far less.
Figure 6 Clamping the HiveAP 28 to a Wire Strand
To mount the HiveAP 28 on a wire or strand, you need a wrench and two 1/4-20 bolts, split washers, strand clamps,
and 90-degree type N adapters. In the following instructions, you use only the 2.4 GHz antennas.
1. Position the HiveAP 28 so that its long side (with three holes at each end) is underneath a cable or wire strand
running lengthwise along the upper side of the chassis (for the proper orientation, see the inset in Figure 6 ).
2. Place the strand clamp over the wire and use the 1/4-20 bolt and split washer to secure the strand between the
clamp and chassis.
3. Attach the 90-degree type N adapters to the two 2.4 GHz antenna connectors and then attach the antennas to
the adapters so that the antennas face downward. For details, see "Attaching Antennas" on page 42 .
Note: Repeat the preceding steps to fasten the other end of the HiveAP 28 to the cable or wire strand.
ͬ®¿²¼ Ý´¿³°
Í°´·¬ É¿-¸»®
ͬ®¿²¼
ïñìóîð Þ±´¬
Û²¼ Ê·»©
Í·¼» Ê·»©
Í·¼» ª·»© ±º ¬¸»
Ø·ª»ßÐ îè ³±«²¬»¼
±² ¿ ½¿¾´» -¬®¿²¼
çðóÜ»¹®»»
̧°» Ò ß¼¿°¬»®
çðóÜ»¹®»»
̧°» Ò ß¼¿°¬»®
îòì Ùئ ß²¬»²²¿-
Note: For clarity, only one bolt, washer,
and strand clamp are shown in the
illustration on the left. You also need to use
a second set of these items to finish
clamping the HiveAP to a wire strand.
Position the HiveAP 28 so that
its long side is directly beneath
a cable or wire strand.
Place the strand clamps over the
wire, and bolt the clamps tightly to
the chassis around the strand.
1
2
Attach 90-degree type N adapters to the
2.4 GHz antenna connectors so that the
adapters face downward, and then
attach the antennas to the adapters
3