Aerohive BR200-WP, Справочник по аппаратуре

Страница: 16 / 124

Chapter 1 AP110 and AP120 Platforms
14 Aerohive
4. Holding the AP upside down, raise it until the threaded stud on the track clip enters the hole on the AP.
Then revolve the AP until it is firmly attached to the clip. See Figure 6 .
Figure 6 Attaching the AP to the track clip
5. When you have the AP in the correct location, cut or drill a hole in the ceiling through which you can
then pass the Ethernet and power cables. Pass the cables through the hole and attach them to the AP.
6. When done, adjust the ceiling tiles back into their former position.
Locking the AP
To lock the AP to a secure object, use a Kensington lock and cable. Loop the cable around a securely
anchored object, insert the Kensington lock in the device lock slot in the AP, and engage the locking
mechanism ( Figure 7 ).
Figure 7 Locking the AP with a Kensington security lock
You can also mount the AP to a solid ceiling—or the underside of any horizontal object such as a
cross beam—using three #6 or #8 screws. Position the three screws in a T-shaped layout: two
screws 2" (5 cm) apart from each other and the third screw center-aligned between them and
4.75" (12 cm) away. Then attach the AP to the screws as explained in
"Surface Mount" on page 15 .
4
With the AP upside down, lift it
until the threaded stud on the
track clip enters the hole in
the AP. Rotate the AP until it is
securely attached to the clip.
AP
Device lock slot
Kensington security lock
Loop the cable around a secure object,
such as a support beam, and then insert
the T-bar component of the lock into the
device lock slot on the AP and turn the
key to engage the lock mechanism.
AP mounted to a
ceiling track Support beam
Ceiling track
(shown as
transparent)