Aerohive BR200-WP, Справочник по аппаратуре

Страница: 108 / 124

Chapter 11 The HiveManager Platform
106 Aerohive
R
ACK
M
OUNTING THE
H
IVE
M
ANAGER
You can mount the HiveManager in a standard 19" (48 cm) equipment rack with two rack screws—typically
3/4", 1/2", or 3/8" long with 10-32 threads. The HiveManager ships with mounting brackets already attached
to the left and right sides of the front panel (see Figure 1 on page 104 ). In this position, you can front mount
the HiveManager as shown in Figure 3 . Depending on the layout of your equipment rack, you might need to
mount the HiveManager in reverse. To do that, move the brackets to the left and right sides near the rear
before mounting.
Figure 3 Mounting the HiveManager in an equipment rack
1. Position the HiveManager so that the holes in the mounting brackets align with two mounting holes in the
equipment rack rails.
2. Insert a screw through a washer, the hole in one of the mounting brackets, and a hole in the rail.
3. Tighten the screw until it is secure.
4. Repeat steps 2 and 3 to secure the other side of the HiveManager to the rack.
Rack rails
Mounting
bracket
Washer Rack
screw