Aerohive BR200-WP, Справочник по аппаратуре

Страница: 62 / 124

Chapter 5 The AP340 Platform
60 Aerohive
Figure 12 Suspending the AP340
6. Attach antennas to the antenna connectors on the AP340, connect one or two Ethernet cables to the
network, and—if not using PoE—connect the power cord to a power source.
Height Correction
If you accidentally pull too much wire rope through the locking device, raising the AP340 too high, and you
then need to lower it, do the following: Take a tool, such as a screw driver with a 1/8" flat tip, and press it
against the lip of the inner tube in the opposite direction from the arrow on the outside of the locking device
(see
Figure 13 ). This releases its grip on the rope, allowing you to pull the rope out the same way it was
inserted. While maintaining pressure on the tube, adjust the rope until the AP340 is at the height you want.
When you are satisfied, stop pressing against the tube so that it can regain its grip on the rope.
Figure 13 Releasing the wire rope from the locking device
Clip
3
Wrap the wire rope around a beam, clip the hook to the rope, and then pull the rope
down until it is taut against the beam.
Pull downward
on the rope
Beam
Locking
device
Loop at top of
quad-toggle
Quad-toggle
Mounting plate
AP
Locking device
4
Push the wire rope down
through the vertical side
hole in the locking device
and through the loop in the
quad-toggle.
5
Push the wire rope up through the
center hole in the locking device.
Continue pulling the rope to raise
the AP to the height you want.
Press against the lip of the inner tube and
hold.
While pushing the tube inward, pull the wire rope out.
Locking device
Wire rope
Screwdriver