Aerohive BR200-WP, Справочник по аппаратуре

Страница: 68 / 124

Chapter 6 AP330 and AP350 Platforms
66 Aerohive
Reset Button
To reset the device, or return to the factory configuration, insert a paper clip, or similar tool, into the Reset
pinhole and press the reset button. To reboot the device, hold the button down for 5 seconds. To return the
configuration to the factory default settings, hold it down for at least 10 seconds. After releasing the button,
the Power LED goes dark, and then glows steady amber while the firmware loads and the system performs a
self-test. After the software finishes loading, the Power LED glows steady green.
To disable the reset button from resetting the configuration, enter this command:
no reset-button
reset-config-enable
Pressing the button for 5 seconds will still reboot the AP, but pressing it for more than
10 seconds will not reset its configuration.
USB Modem Port
When configured as routers, AP330 and AP350 devices can use a wireless USB modem for a WAN
connection. The typical use of the USB modem is to act as a backup to the ETH0/WAN interface; however,
for locations where an Ethernet connection to the WAN is not possible, you can use the USB modem as the
primary (and only) interface to the WAN.
Status Indicator
The status indicator appears in the triangular region on the top surface of the AP330 and AP350. It is
illuminated by various colors to indicate different states of activity. The meanings of the colors are as follows:
•
Dark
: There is no power or the status indicator is disabled.
•
Blue
: (solid) The device is booting up or there is no backhaul link; (flashing) the device is shutting down.
•
Green
: The default route is through the backhaul Ethernet interface, but not all conditions for normal
operations (white) have been met.
•
Yellow
: The default route is through a backhaul wifi interface, but not all conditions for normal
operations (white) have been met.
•
White
: The device is powered on and the firmware is operating normally; that is, the AP has made a
CAPWAP connection to HiveManager.
•
Purple
: A new image is being loaded from HiveManager.
•
Orange
: An alarm indicating a firmware or hardware issue has occurred.
For locations where the status indicator might be a distraction or attract unwanted attention, you can adjust
its brightness level from bright (the default) to soft to dim. You can even turn it off completely. In
HiveManager, choose the brightness level that you want from the LED Brightness drop-down list on the
Configuration > Advanced Configuration > Management Services > Management Options page. Through
the CLI, enter
[ no ] system led brightness { soft | dim | off }
. The various brightness levels are
shown in Figure 2 . (Although the AP330 is shown in the illustration, the same settings also apply to the AP350.)
Figure 2 Status indicator brightness levels
When using a wireless USB modem on an AP330 or AP350, you must connect it to an AC power
source instead of using PoE to power the device.
Brigh Soft Dim Off