aero-stream AS1000-2, Инструкция по установке и эксплуатации

Страница: 24 / 38

24
© Aero-Stream, LLC 2022
102822 Rev. H
12. If the air line is not of sufficient length, measure the distance in feet from the air compressor to the
end of the air line. Contact Aero-Stream to purchase a properly sized air line extension kit to connect to
the air line packaged with the product. An improperly sized air line will detrimentally affect the
performance and life of this product and may void the warranty.
WARNING: Do not cover or encase the air compressor as adequate ventilation is required to
keep the motor cool.
Installation Process
–
Aero-Alert Alarm
Figure 36, Alarm and Float Switch Overview
13. Install the tee fitting in the output air line of the Aero-Stream unit (Figure 36). Secure the air line with
provide cable ties.
14. Connect the 1/8-inch air line from the tee to the black barbed fitting on the bottom of the Aero-Alert
(Figure 37).
15. Connect air line from sintered diffuser or manifold assembly to output of tee fitting from step 1
(Figure 32, Figure 33, Figure 34, Figure 37)
16. Push the Aero-Alert post into the ground three-(3) to five-(5) inches. If the ground is hard use a ¾-
inch diameter wood or metal stake and a hammer to make three-(3) to five-(5) inch deep holes and
push the Aero-Alert post into the formed hole. DO NOT HAMMER ON THE Aero-Alert enclosure to
drive the unit into the ground.
Weighted Base
Float Switch
Mast
Wire to Alarm
ON/MUTE/TEST
Switch
Light
Identification
Tag
Siren
To Compressor
To Float
Switch
FRONT VIEW
BACK VIEW
Post