Installation and Operation Manual
AENO
TM
air purifier
©
ASBISc Enterprises PLC. All rights reserved
Document version: 1.0.2, aeno.com
Page
7
of
43
1.
The device is designed for use at home, in offices and other similar
environments. Do not use it in an industrial environment.
2.
Place the device on a dry and clean horizontal surface, making sure there is no
chance of it toppling over. Never tilt the device while it is operating.
3.
Do not install the device near open flames, hot surfaces, or heating appliances.
Avoid direct sunlight and exposure to other potential heat sources.
4.
Do not use the device in an area where flammable substances such as
hairspray, sprays, deodorants, etc. are sprayed.
5.
Do not use the device in rooms with extreme temperature fluctuations, in a
humid atmosphere, or where it may be exposed to splashes, drips or
condensation (for example, over an electric kettle), to avoid fire and/or electric
shock.
6.
Do not place the device:
•
in a draft
–
near air conditioners, doors, windows, exhaust fans, etc;
•
over the sink or stove;
•
in confined spaces (e.g., in a closet or under a closet);
•
in places where the device can be blocked, such as curtains or furniture.
7.
The device does not remove carbon monoxide or radon. Do not use it to
eliminate the effects of combustion processes or air pollution by hazardous
chemicals. Do not use the device in an area where the air contains particles of
oil.
8.
The device cannot be used to replace a vent or hood while cooking.
9.
Before you connect the device to the mains, check that the rated voltage
indicated in the technical documentation corresponds to the electrical voltage
of the outlet.
10.
Before turning on the device, make sure that there is no packing material on
the filter and that the filter is installed according to the instructions
11.
Connect the device only to a grounded power outlet. Do not use an extension
cord.
12.
Plug the power cord in and unplug it from the outlet only with dry hands.
13.
Place the power cord so that it cannot be accidentally stepped on or snagged.
14.
Do not place the power cord on anything with a sharp edge and do not place
anything on top of the cord.
15.
Make sure that the power cord does not hang over the edge of furniture or
touch surfaces that could damage the insulation.
16.
Do not wrap the power cord around the device.
17.
If the power cord is damaged, first power off the outlet, then unplug the device.
The power cord should only be replaced by a service technician.
18.
Always unplug the power cord after use or before cleaning the unit.
Содержание AAP0004
Страница 1: ...Installation and Operation Manual for the AENOTM Air Purifier Model AAP0004 v 1 0 3 14 04 2023 ...
Страница 2: ......
Страница 42: ......
Страница 43: ......
