Water-stop device
The inlet hose is provided with a water stop device,
which protects against damage caused by water leaks in
the hose which could develop due to natural ageing of
the hose.
This fault is shown by a red sector in the window “A
A”.
Should this occur, turn the water tap off and refer to
your Service Centre to replace the hose.
Water drainage
The end of the drain hose can be positioned in three ways:
Hooked over the edge of a sink using the plastic hose guide supplied
with the machine.
In this case, make sure the end cannot come
unhooked when the machine is emptying.
This could be done by tying it to the tap with a piece
of string or attaching it to the wall.
In a sink drain pipe branch.
This branch must be
above the trap so that the bend is at least 60 cm above
the ground.
Directly into a drain pipe at a height
of not less
than 60 cm and not more than 90 cm.
The end of the drain hose must always be
ventilated
, i.e. the inside diameter of
the drain pipe must be larger than the outside diameter of the drain hose.
The drain hose must not be kinked.
Important!
The drain hose may be extended to a maximum of 4 metres. An additional drain
hose and joining piece is available from your local Service Centre.
41
Installation
A
3
52
P1118
132960250.qxd 18/09/2008 14.29 Pagina 41
