40
The machine must not be installed in rooms where
the temperature can drop below 0. The water inlet
hose and the drain hose must not be kinked.
Please ensure that when the appliance is installed, it
is easily accessible for the engineer in the event of a
breakdown.
Carefully level by screwing the adjustable feet in or
out. Never place cardboard, wood or similar materi-
als under the machine to compensate for any unevenness
in the floor.
Automatic foot:
The rear foot on the left-hand side of your washing machine is
built as a shock absorbing foot, which is why the appliance gives in the back left-
hand corner if put under load. The automatic foot guarantees that the appliance
does not move even at high spin speeds. Basically the automatic foot does not
need to be set.
Water inlet
An inlet hose is supplied and can be found inside the machine drum.
Do not use the hose from your previous machine to connect to the
water supply.
This appliance must be connected to a cold
water supply.
1.
Open the porthole and extract the inlet hose.
2.
Connect the hose with the angled connection to
the machine.
Do not place the inlet hose downwards. Angle
the hose to the left or right depending on the
position of your water tap.
3. Set the hose correctly by loosening the ring nut.
After positioning the inlet hose, be sure to tighten
the ring nut again to prevent leaks.
4. Connect the hose to a tap with a 3/4” thread.
Always use the hose supplied with the appliance.
The inlet hose must not be lengthened. If it is too
short and you do not wish to move the tap, you
will have to purchase a new, longer hose specially
designed for this type of use.
Installation
HEC007S
HEC0006
132960250.qxd 18/09/2008 14.29 Pagina 40
