4.
Slide out the relevant plastic spacers
.
5.
Open the porthole, take out the inlet hose from the
drum and remove the polystyrene block fitted on the
door seal.
6.
Fill the smaller upper hole and the two large ones with the corresponding plastic
plug caps supplied in the bag containing the instruction
booklet.
7.
Connect the water inlet hose as described under the
paragraph «Water inlet».
Positioning and levelling
Install the machine on a flat hard floor.
Make sure that air circulation around the machine is not impeded by carpets,
rugs etc.
Before placing it on small tiles, apply a rubber coating.
Never try to correct any unevenness in the floor by putting pieces of wood,
cardboard or similar materials under the machine.
If it is impossible to avoid positioning the machine next to a gas cooker or coal-
burning stove, an insulating panel covered with aluminium foil on the side facing
the cooker or stove, must be inserted between the two appliances.
39
Installation
HEC0010
HEC0005
132960250.qxd 18/09/2008 14.29 Pagina 39
