Advanced Quick Zone XL, Инструкция по установке, пусконаладке и эксплуатации

Страница: 25 / 68

25
Set Fault Buzzer Volume
There are two levels of volume for the internal fault buzzer, high
and low.
Enter the above code and press the ENTER button to increase or
decrease the fault buzzer tone from the previous level.
Setting will change when ENTER button is pressed.
When finished, enter the next p
rogramming code or disable the controls and return DIL switch 6 to ‘OFF’.
Clear All Disablements
Enter the above code and press the ENTER button.
Then press the ENTER button again and hold for 3 seconds.
Any disabled zone, sounder circuit, output or delay will now be
enabled.
The panel will bleep to acknowledge the reset.
When finished, enter the next programming code or disable the controls and return DIL switch 6 to ‘OFF’.
Initialise Factory Default Settings .
Enter the above code and press the ENTER button.
Then press the ENTER button again and hold for 3 seconds.
Any disablements or test mode settings will now clear and all
engineering option parameters will revert back to factory settings.
The panel will bleep to acknowledge the reset.
When finished, enter the next programming code or disable the controls and return DIL switch 6 to ‘OFF’.
www.acornfiresecurity.com
www.acornfiresecurity.com