ADVANCED UV LIGHT Future Sun HP, Руководство пользователя

Страница: 11 / 73

11
Futuresun HP V2
Basic Safety Instructions

Observe all Safety Instructions attached to the
sunbed and provided in this manual.
 Only authorized and skilled staff is allowed to
transport, assemble, start-up and disassemble the
sunbed.
 Service personnel of Advanced UV Light GmbH
and its authorized distributors’ are considered as
trained staff with the necessary expertise. This also
includes skilled electrical personnel who, due to
their training and expert knowledge, can provide
appropriate handling and service and who are
aware of all potential dangers.

Avoid any use or handling which may result in
safety risks.
 Transportation, disassembly, assembly,
maintenance and cleaning jobs (i.e. of low-
pressure lamps) must only be performed after the
unit has completely cooled down.
Electrical connection
 Operation of the sunbed is only allowed if the
unit is connected and secured on the site, in
compliance with the technical requirements as
stated on the type label and in accordance with
local electrical standards.
 Operation of the sunbed is only allowed, if the mains
disconnection switch, is installed at the site.

Ensure that liquids ( i. e. cleaning solution) do not
get into the sunbed. Ensure that liquids inside the
sunbed (SunFresh container and condensation
water container) do not get spilled. In case any
liquids have entered into the sunbed, stop mains
supply immediately with the mains disconnection
switch and secure with it lock and key. Take care
that the unit is checked by authorized service
personnel prior to operating the unit again.

Prior to performing any jobs on the sunbed,
i.e. transportation, assembly, disassembly,
maintenance and cleaning, the mains supply
must be switched off. In addition, the mains
disconnection switch must be secured with lock
and key against unauthorized or accidental turn on.
Safety Provisions
 Use this sunbed only when in fault-free technical
condition. All protection and safety devices must be
assembled and in working condition.

Use the sunbed only with installed front cover plate.
 All DANGER-labels and notices must be replaced
immediately when damaged.

Do not use the sunbed with defective filter(s) and/or timer.
Site of Installation

Do not install the sunbed in damp rooms or in
rooms where there is a risk of explosion.
 Do not keep or store any containers with explosive
materials, i.e. spray cans, close to the sunbed.
 Smoking and open flames are prohibited within
proximity of the sunbed.

Do not expose materials that may fade or suffer
damage from UV-light exposure to the UV-rays
emitted from this sunbed.
Safety instructions for Operation
 Before you start to operate the sunbed, check the
unit for correct set-up and make sure that all safety
devices are provided and in working condition:
– bench acrylic
– top acrylic
– facial filters glasses
– exhaust air disposal

Do not cover or block ventilation (i.e. air entries) or
cooling devices to avoid potential thermal damage.
 Before and after each use, check the sunbed for
obvious outer damages or defects and replace or
repair immediately.
 Defects which may affect the safe operation of
the sunbed must be communicated immediately
to the operator/owner or the responsible person
in charge. Discontinue the use of this sunbed until
these defects have been removed.
Safety Instructions for Transportation

All devices used for transportation must be
adequate to the weight of the sunbed.
 All applicable standards and regulations to prevent
accidents at the workplace must be observed.
 All paths of transportation must be blocked to traffic
and clearly marked to prevent injuries caused by
transportation vehicles or the load.