Spatial FOG Dual ETH
Supplementary Reference Manual
Page 16 of 29
Version 1.2
10/09/2019
11.8
Configuration
Refer to the Spatial FOG Dual Reference Manual.
11.8.1
Configuration Export
Refer to the Spatial FOG Dual Reference Manual.
11.8.2
Filter Options
Refer to the Spatial FOG Dual Reference Manual.
11.8.3
Packet Rates
Refer to the Spatial FOG Dual Reference Manual.
11.8.4
Alignment Configuration
Refer to the Spatial FOG Dual Reference Manual.
11.8.5
Baud Rates
It is strongly recommended you do not modify the baud rates for the Primary port. The baud rate is
pre-configured to communicate at 115200 bps directly with the Ethernet interface. If it is necessary
to change this rate, it must also be changed on the Ethernet interface to match. Please contact
before you make any changes.
Using Spatial FOG Manager you can modify the Auxiliary and GPIO port baud rates to suit your
requirements.
When changing baud rates, some Microsoft Windows machines are unable to function at the
higher baud rates. It is recommended to test the baud rate first with the permanent box unticked.
This way, if it is not possible to communicate at the higher baud rate, a power cycle can be used to
revert to the previous baud rate.
Illustration 2: Screenshot of
Spatial FOG Manager baud
rates dialogue
