Integrating ADTRAN eSBC and NEC SV8100
Configuring the NEC SV8100
6AOSSG0027-42A
Copyright © 2015 ADTRAN, Inc.
19
Configuring Trunk Groups and Trunk Priority (14-05: Trunk Groups)
Assign the configured SIP trunks (i.e.,
29
,
30
,
31
, and
32
) to a trunk group, and assign the SIP trunks the
highest priority. To configure trunk priority and trunk groups, follow these steps:
1. Select the
System Data
tab, then select
14-XX: Trunk Setup > 14-05: Trunk Groups
from the
System
Data
pane. The
14-05: Trunk Groups
menu will appear.
2. In the
14-05: Trunk Groups
menu, perform the following:
a. For each SIP trunk configured on the system, enter the same number in the provided
Trunk
Group
field to assign the SIP trunks to the same trunk group.
b. For each SIP trunk configured on the system, enter
1
in the
Priority
field. Specifying
1
assigns the
trunks the highest priority.
3. Select
Apply
to apply the settings.
Configuring SIP Trunk Routing (14-06: Trunk Group Routing)
Trunks are selected based on priority (optionally, Round-Robin). The SIP trunks configured on the system
should be given the highest priority. To give the SIP trunks the highest routing priority, the SIP trunk group
should be assigned to the first entry of the highest priority in the route table. To configure trunk group
routing for the SIP trunk group, follow these steps:
1. Select the
System Data
tab, then select
14-XX: Trunk Setup > 14-06: Trunk Group Routing
from
the
System Data
pane. The
14-06: Trunk Group Routing
menu will appear.
2. In the
14-06: Trunk Group Routing
menu, enter the SIP trunk group number configured in
Configuring Trunk Groups and Trunk Priority (14-05: Trunk Groups) on page 19
in the first field of
the route table. This is the field in
Route Table 001
with
Priority Order 1
.
3. Select
Apply
to apply the settings.
Configuring Trunk Access (14-07: Trunk Access Map Setup)
By default, all trunks are given full incoming, outgoing, and hold access. To verify that the SIP trunks (i.e.,
29
,
30
,
31
, and
32
) are configured for full access, follow these steps:
1. Select the
System Data
tab, then select
14-XX: Trunk Setup > 14-07: Trunk Access Map Setup
from
the
System Data
pane. The
14-07: Trunk Access Map Setup
menu will appear.
2. In the
14-07: Trunk Access Map Setup
, verify the SIP trunks are configured with the
OTG/INC/Hold
option.
3. Select
Apply
to apply the settings.
