ADT ACCORD XPC, Руководство по установке

Страница: 43 / 62

37
Accord xpC - July, 2001
Group 9 — Option 5 Restore Signals on Unset or Reset
This option has two settings:
0. Restore on Unset.
1. Restore on Reset.
If set to 0 (Restore on Unset) the restore signal is sent, after an alarm condition during a
set state, when a user code is entered to unset the system.
If set to 1 (Restore on Reset) the restore signal is sent after an alarm condition during a
set state, when the system is Reset.
This option affects High Speed format only.
This option defaults to 0 (Restore on Unset).
Group 9 — Option 6 Entry Deviation Permitted
This option has two settings:
0. Entry deviation not permitted.
1. Entry deviation permitted.
If set to 0 (Entry Deviation not permitted), deviation from an entry route during entry or
supplementary entry periods will result in a Full Alarm Condition.
Entry Deviation permitted (1), starts a 30 second time window when deviation occurs.
During the 30 seconds an internal alarm warning should sound. External bells/
communications/triggers, will be withheld until 30 seconds has passed or the entry period
ends. Entering a valid code before a full alarm condition, prevents communication of
triggers.
This option defaults to 0 (Entry Deviation not permitted).
Group 9 — Option 7 Print Event Log
This option allows the system event log to be printed by a serial printer.
0. No Event Log Print
1. Print Event Log
The Event Log is printed from Programming Mode by pressing 971 then exiting
Programming Mode. On exiting Programming Mode, this option automatically resets to
0 and the log will not print again until this operation is repeated.
This option defaults to 0 (No Event Log Print).
Note: See Appendix B for instructions on connecting a printer to the system.
Group 9 — Option 8 Factory Defaults
The control panel programming can be reset to the factory defaults.
0. No Reset
1. Reset (981 must be entered twice).
This option defaults to 0 (No Reset).