ADLY MOTO GK-125R, Руководство по обслуживанию

Страница: 4 / 111

ASSEMBLY INSTRUCTION
(For GK-125R )
1. Take out the battery and fill with acid liquid. Pre-charge the battery will extend
its life. The preparation and charge procedure is based on the battery’s
instruction.
2.
Install the rear wheels and parts in the following order:
A.
16x40x5mm washer.
B. 16mm hex-bolt (torque 750~950 kg-cm, 74~93 N-m).
C. Cotter pin (open up the end after installed).
D. Rubber cap.
3.
Install the front wheels and parts in the following order:
A. 12x40x4.5mm washer.
B. 12mm hex-bolt (torque 300~350kg-cm, 29.5~34N-m).
C. Cotter pin (open up the end after installed).
D. Rubber cap.
4.
Install the battery with the red wire to positive (+) and black wire to the negative
(-). After the battery is connected, put the plastic cover on it. Place the steel
bracket over the cover and tie up with 2 hex-bolts.
5.
Install the fuel tank on the rear rack and fuel valve on the frame. Fill up with
unleaded fuel and turn the fuel valve to ON position.
6.
Install the seat from front. Pull the lock lever under the seat and fit into the seat rail.
Push back to set into proper position and release the lock lever.
7.
Install the L/R roller cage tube started from the front of frame. Push the clip on the
frame and set tube onto the frame. Install the rear tube to the frame.
8.
Install the top roller cage cross tube. The shorter tube is in the front and longer one
for the rear. Tie-up 4 hex-bolts to fix the top roller cage cross bar and 4
hex-socket bolts to fix the L/R tube on the frame.
9.
Turn on the main switch and try to start the engine. In order to use the electric
starter, you need to check the following:
A.
Step on the brake pedal for safety.
B. Turn the main switch to right in order to start the engine.
C. Do not continue to start up the engine for more then 10 seconds.