ADLINK Technology NuPRO-900A, Руководство пользователя

Страница: 36 / 49

Getting Started
•
27
To install either type of module follow these procedure:
Figure 7: Inserting DIMM into Socket
1. Align the module to the socket so that the edge connectors on the
module match the socket sections.
2. Hold the module perpendicular to the motherboard and press the
edge connector into the socket.
3. Press the module fully into the socket so that the socket retaining
arms swing up and engage the retention notches at each end of the
module.
4. Following the configuration you have chosen, repeat this procedure if
necessary so that all modules are installed.
5. Once the modules are installed, system memory installation is
complete.
3.3 Connecting IDE Devices to the NuPRO-900A
The NuPRO-900A supports two IDE channels, Primary and Secondary. It has
two IDE device connectors onboard which support IDE devices running in any
data transfer mode up to ATA-100. Each IDE connector supports two drives, a
Master and a Slave. The drives connect to the NuPRO-900A with an IDE
ribbon cable.
To install an IDE drive, connect the drive to one of the drive connectors to a
suitable ribbon cable. Plug the board end of the cable into one of the IDE
connectors on the NuPRO-900A. Make sure pin 1 of the ribbon cable
connector is probably align with pin 1 of the IDE device connector.