7
FL-Cool-200629-Rev003-UM-en
Inserting the cutting set
Before inserting the cutting set, first insert the worm housing and lock it with the lock screw (1). Pay
attention to correctly placing when inserting the worm housing (2).
The worm shaft (15+16) is introduced so that the shaft is first introduced with the drive shaft in the
worm housing. It is pushed backwards and the worm shaft is rotated until it engages with its drive
shaft at the rear end in the uniform slot of
the drive.
Now, the precutter (68) is pushed onto the
stub shaft and rotated so that the
rectangular recess slides on the disc edge
over the same shaped ridge of the worm
housing.
It follows the first cross blade (20). It is
important to ensure that the knife blades
are aligned counter-clockwise.
Then, place the perforated disc (17a) on
the stub shaft.
This is followed by the second cross knife
(20). Make sure that it is in the correct position again (cutting edges point in the direction of
rotation).
Then the second perforated disc (17b) is added.
Then, place the spacer ring (69) in this way, that the nose of the
spacer ring engages the notch
of the perforated disc (17b)
provided for this purpose.
The hand wheel (6) forms the
end, which is first slightly
tightened and then released
by
approx. 5°
. The latter is
particularly important because
the worm shaft must have
some clearance in the
longitudinal direction for proper functioning of the mincer.
NOTE for use of distance rings:
For use of 5-piece UNGER cutting set narrow distance ring and for use of 3-piece cutting set wide
distance ring has to be mounted.
5°
1
2
3
15+16
68
20
69
17(b)
6
17(a)
20
