9
FL-Cool-200629-Rev003-UM-en
The reverse mode switch should only be activated when required, e.g. when a small bone has entered
the worm together with the meat and has become entangled.
Make sure that the cutting set and worm are properly positioned in the worm housing. Check the seat
of the hand wheel again. To ensure safe operation of the cutting set, first tighten the hand wheel
slightly and then loosen it by
approx. 5°
counter-clockwise.
Switching on
For the standard operation of the meat mincer, turn the programme selector to the left to the “I”
position.
Now start the operation of the worm by pressing the “ON” button (green light edge lights up). The
worm now starts to turn counter-clockwise.
Switching off
To stop the worm, press the “OFF” button (red light edge).
To turn off the device, turn the programme selector to the “O” position.
In operation
Turn on both the machine and the thermostat (see the following section) and wait about 10 minutes
for the set cooling temperature to be reached.
Make sure the cutting set is installed correctly and the hand wheel is seated as described in “Setting
up the meat mincer”.
Open the filler pan cover and fill in the pieces of meat. If necessary, cut the meat into pieces of
suitable size.
Switch on the meat mincer and push the meat in the feed funnel to reach the worm using the pusher.
Feed the meat evenly and by applying little pressure into the funnel. Avoid overstuffing.
Never operate the meat mincer at idle without meat in order to prevent
overheating of the cutting set or worm housing leading to irreparable damage.
Never reach into the filling shaft with your hands or insert other objects such as
sticks, cooking utensils, etc. into the filling shaft! There is a risk of injury!
Using the cooling system
The cooling temperature is usually preset during commissioning thanks to the thermostat. The
optimum temperature is determined individually and can be determined by the passage of various
samples through the cooled worm housing and gradually optimised. The thermostat allows values to
be set between -50 °C and +99 °C. The recommended preset value of cooling temperature is +2 °C.
When the device is connected to the local power supply, the cooling system is initially off and the
thermostat display shows the “OFF” symbol
.
Thermostat for cooling system
