Acquisition modes
MSX-E3701-DIO
Example
To acquire four sequences after the start, the field “Number of sequences” must contain the value 4.
Fig. 7-12: “Number of sequences” (example)
Start enable
Acquisition
In the field “Number of data frames”, you need to define the number of sequences (1 to 4096) that
have to be acquired before the measurement values are sent to the target system.
NOTICE!
The value entered must not be higher than the value in the field
“Number of sequences”. The latter must be divisible by this value.
If the MSX-E system does not have sufficient memory to store the required number of sequences, the
measurement values are sent earlier, that is, before the maximum number of sequences to be acquired
is reached. This helps to reduce the network traffic load and the CPU resources of the MSX-E systems.
Example
After the start, two sequences are acquired. Then the measurement values are sent to the client.
Fig. 7-13: “Number of data frames” (example)
Start enable
Acquisition
Send 2 seq.
Send 2 seq.
www.addi-data.com 37
