Web interface: Quick access to the MSX-E system
MSX-E3701-DIO
In the
ConfigTools
program, transducers that are to be used for the acquisition, have to be copied
into the MSX-E database. The transducer properties can be changed in the User database of this
program (see also Chapter 3.2).
The table above displays the content of the MSX-E database. By clicking on the “Reload” button, the
table is refreshed.
6.2.2
“Diagnosis” tab
Fig. 6-5: I/O Configuration: Diagnosis
To carry out a transducer diagnosis, you have to click on “Start”.
The list above shows if on the primary or secondary side of the transducer, a short-circuit has occurred.
If no transducer is connected or if there is a line break, this is also indicated.
In case of a short-circuit, the required rearm can be carried out via the correspondent button.
Please find further information on this in Chapter 4.4 of this manual.
The diagnosis should be repeated in the event of transducer changes, errors such as a short-circuit or
after a certain time.
6.3
Menu item “Acquisition”
6.3.1
“Auto-refresh” and “Sequence” tabs
Fig. 6-6: Acquisition modes: Auto-refresh and Sequence
For the acquisition, the Auto-refresh mode and the Sequence mode are available. A detailed
description of these modes can be found in Chapter 7 of this manual.
The acquisition is started and stopped in the tool bar above (“Start” and “Stop” buttons). In addition,
the configuration can be saved in a file (“Save as”) and later be reloaded (“Load configuration”).
Moreover, you can display the source code as a C sample (“Source code”).
On these tabs, also the data format (see Chapter 7.3.5) is shown for each transducer input.
www.addi-data.com 30
