ADC Ultra-8/16, Руководство оператора

Страница: 7 / 27

7
Audible Signals
The keypad emits signals (beeps) in response to User activities. These signals are
listed in Table.
Table: List of Audible Signals
Sound Sequence Description
Short beep Once only A key in the keypad has been pressed
3 short beeps Once only Operation carried out successfully
Long beep Once only Illegal operation, or wrong key pressed
Slow beeping Through the Exit or
Entry delay time Exit or entry delay warning when arming
the system indicates that you must exit the
protected area,
also Entry delay warning when entering
via the entry zone, to disarm the system.
Indicators
The indicators show the status of the system. The LED indicators are listed in Table 2.
Table: List of LED Indicators
Design. Function
Bypass Indicates that there are bypassed zones
Stay Indicates that the system is armed in STAY mode
Armed Indicates that the system is fully armed, or a partition is armed
Ready Indicates that the system is ready to be armed
Trouble Indicates system failure, or problem. Make note of system message
and call service
KEYPAD TAMPER (wrong code alarm)
A wrong code or Keypad Tamper alarm is generated by the Ultra-8/16 after 4 consecutive
invalid code entries. The controller will not “Lock-Out” the keypad at this point but simply
create an alarm condition that may be reported to a monitoring company via the dialler.
Entry of a valid user code will reset the Keypad Tamper alarm, however, the alarm event
will be written into memory and the keypad will display “New Event” indicating the
presence of a new memory entry.