18
Press
<PROGRAM>
enter
Master code
and
<ENTER>
. The
Program
indicator lights
up to indicate that the system is in User programming mode.
If you get a single long beep at this point and the Program LED doesn’t turn on, it means
your code cannot access Program mode.
How to exit program mode
To exit out of program mode press
<PROGRAM>
and
<ENTER>
.
The LCD display shows the system type, date and time.
How to Change or Add Codes
About Master code and User code
The factory default master code (123) is intended as a preliminary control of the alarm
system. After FreeWave is installed and put into service, the code can be changed to
any code known to the Master user. The Master user can define up to 99 user codes. To
limit access rights, the holder of the Master code can ask the installer to define several
User profiles.
Access rights are listed below:
-
User code has Area A and/or B or C or D permission
-
User code can arm and/or disarm arm an area
-
User code can arm and/or disarm arm an area in Stay mode
-
User code can change their code
-
User code can change user’s code
-
User code can change dialer telephone numbers
-
User code can alter the real time clock
-
User can answer an incoming call and start up/down load
-
User can allow access to installer program mode from client mode.
-
Initiate Walk-test mode.
How to Change Master Code
While in
CLIENT
mode, Press <
PROGRAM
> and
1
to change Master code press
<ENTER>, the code digit will be flashed back to you. Use the numeric keyboard to enter
your new Master code. The code can hold any combination of
1 to 6
digits. It is
recommended using a multi-digit code. . Press <
ENTER
> to save your new code, the
Ultra - 16
TIME
DATE
Содержание Ultra-8/16
Страница 27: ...27 Notes...
