ADC Ultra-8/16, Руководство оператора

Страница: 12 / 27

12
During this delay time, a slow beeping is heard to indicate that the system is not armed
yet and reminds you to leave the protected area.
If you must disarm the system during the exit delay, press <
ARM
>.
Disarming the System
Enter
User’s code
and press <
ENTER
>.
The following system message is displayed:
Stopping Resetting Alarms
In case of an alarm condition
Enter
User’s code
and press <
ENTER
> to stop alarm any time, and turn off any audible
sirens.
How to Arm the System when Staying Home
This type of arming is used when people are present within the protected area. At
nighttime, when the family is about to retire, perimeter zones are protected, but not the
interior zones. Consequently, interior movements will be ignored by the system.
When the system is Ready,
press <STAY>
and the system prompts you to
enter user
code,
and then <
ENTER
>.
Quick Stay
When enabled by the installer, press <
STAY
> to arm the system.
During exit delay you can leave the premises. If you wish to stay or that no one will
enter the protected premises, you may cancel the Entry/exit delay by pressing the
<
ENTER
> key. The slow beeping stops and the system is immediately armed.
At the end of the procedure, the Stay indicator lights up to indicate that the system is
armed and the system message is displayed. (The indicators may go out after a few
seconds, depending on the installer's setting).
Disarming the System
Enter
user’s code
and press <
ENTER
>, or press <
STAY
> if enabled by installer.
The following system message is displayed.
Areas Disarmed
A - - -
Enter Code
****
Areas In Stay
A - - -