ADC Ultra-8/16, Руководство оператора

Страница: 11 / 27

11
Operation
How to Arm the System before Exit
Preparing the System for Arming
Verify that the green <Ready> indicator is lit. This indicator is lit only when all zones are
closed (all doors, exits and windows are closed and motion in the protected area is
restricted or bypassed). If the green <Ready> indicator is not illuminated, the LCD
displays the open zones and descriptions.
Close open zones, or bypass them
. Bypass any zone you cannot close. For details
see page 12.
Note
: Bypassed zones are not protected.
Arming the System
When the system is ready, the LCD display shows the system type, date and time, and
the green <Ready> indicator is lit.
Before leaving premises the system has to be armed.
Arming the alarm system will turn on all detectors in the partition /s being armed.
When the system is Ready,
enter user code
and then <
ENTER
> to arm the system.
The system prompts you to exit the protected area.
There is a exit delay prior to the system being armed. During this delay time you can
leave the premises. At the end of the procedure, the ARMED indicator lights up to
indicate that the system is armed, and the system message is displayed. (The indicators
may go out after a few seconds, depending on the installer's setting).
Quick Arm
When enabled by the installer, press <
ARM
> to arm the system.
Ultra - 16
TIME DATE
Areas Exiting
A - - -
Areas Armed
A - - -
Enter Code
****