ADB Safegate RELIANCE IQ L-852G(L), Руководство пользователя

Страница: 41 / 52

3. Remove the top cover from the bottom cover.
4. Remove the O-ring gasket from the bottom cover, see
Figure 22 .
Figure 20: Fixture upside down Figure 21: Lift up housing Figure 22: Remove gasket
Replace
1. Carefully clean all contact surfaces of the light fixture and of the housing.
2. Install a new O-ring gasket on the bottom cover.
Note
The O-ring gasket must be changed each time the light fixture is disassembled.
3. Connect the LED board cable connector(s) to the Supply Terminal(s) of the converter in the housing. Note the orientation
and alignment of the LED board cables, which are different between 1 connector and 2 connector versions.
Converters with 1 connector: the cables should have colored wires towards each other and crossed.
Converters with 2 connectors: the cables should have colored wires away from each other and crossed. Light fixtures
with only one LED-board need to have its LED-board connected to the LED B channel, see Figure 23 . Place the top cover
over the bottom cover, align A and B sides on the top cover with the corresponding sides on the bottom cover.
Note
Before closing the light fixture, it is important to make sure the O-ring is placed correctly in the groove of the
bottom cover to prepare the light fixture for water tightness checks and use in the airfield.
Figure 23: Converter with 1 connector Figure 24: Converter with 2 connectors
4. Put the light fixture on a surface with the top cover facing down, see Figure 25 .
UM-0197, Rev. 1.0, 2019/11/19 35
Copyright
©
ADB Safegate, All Rights Reserved