ADB Safegate RELIANCE Intelligent Lighting Platform III, Руководство пользователя

Страница: 60 / 118

c) Start a lamp test in lucDMC: Select the CCR with SCROLL tab and click on the start lamp test button.
d) Watch the green LED lamp symbol as well as the timer next to the LED symbol:
Figure 31: Lamp test counter — CCR with SCROLL
The timer is supposed not to run longer than 7 seconds. The green LED symbol should blink for a short while when the
lamp test is finished.
Tip
Switch off the regulator for a short while, swap the sensor cable and repeat the test if the timer counts up in an
uncontrolled way.
3. Check the current flow direction of the external circuit
a) Switch on the series circuit and set is to a brightness level of 10 %.
b) Wait at least 10 seconds for the remotes (remote units) to go into fail-safe mode, which means all light are lighted.
c) Start a lamp test in lucDMC: Select the "CCR with SCROLL tab and click on the start lamp test button.
d) Check whether the lamp feedback is displayed correctly.
In case the lamp symbol is greyed out, the remote has not sent its feedback.
Tip
Swap the external circuit if no feedback is received or detected. If big blocks of lamp feedback is not displayed
(e. g. remotes 12 to 20), the cause may be that the external cabling has been mixed up. In this case the external
circuit can be swapped in the station for testing. Restart the lamp test again in this case. Check whether the
feedback from the previously tested remotes is still missing (the lamp symbol is greyed out). If the feedback is
still missing, you will know from which remote address on to start searching for the mixed up cabling.
RELIANCE Intelligent Lighting
Operation
48
Copyright
©
ADB SAFEGATE, All Rights Reserved