Adam Equipment ACBplus Series, Руководство по обслуживанию

Страница: 10 / 30

@Adam Equipment Company 2005 8
5.0 USER PARAMETERS
•
There are 5 parameters that can be chosen by user to set the scale.
•
To set the parameters press the [Mode] key during self-checking test.
•
After a few seconds, the display will show the first function " ".
•
To view the current settings of each parameter, press the [Zero] key.
•
Press the [Zero] key again to cycle through the other parameters along
with their current settings. For example, if “ ” is displayed with the
weighing unit Pounds, the user will not be able to use this unit while
weighing a sample.
•
Press [Mode] to change the settings of a particular parameter. For
example, to enable the weighing unit pounds change the setting to “ ”
by pressing [Mode] now.
•
Use the [Print] key to leave a parameter unchanged.
•
The following parameters are available:
FUNCTION DESCRIPTION
Sets the units to be used (See section 5.1)
g / ct / Lb / OZ / d / GN / OZt / dWt / MM / TL.T / TL.C / TL.t /t / N /g2.
Sets the backlight (See section 5.2)
: backlight always on
: backlight automatically turns on when a key is pressed
: backlight always off
Sets the print parameters (See section 5.3)
Sets the auto switch-off parameter (See section 5.4)
Pressing
[Zero] will allow the user to enter the technical parameters
setting mode. It is recommended not to proceed with the settings of
these parameters as those are set up at the factory.