ACTEON Equipment SATELEC Implant Center, Руководство пользователя

Страница: 21 / 156

12. 2 PREVENTIVE AND CORRECTIVE
MAINTENANCE
SATELEC recommends inspection or overhaul of
the I-S
URGE
micro-motor at least once a year.
12. 3 FUSE REPLACEMENT
Your I
MPLANT
C
ENTER
is protected by two fuses
located in the power cord (Fig. 2-1).
The replacement procedure is as follows:
- Switch the device off (position O).
- Unplug the power cord from the electricity
supply.
- Unplug the power cord from the receptacle
(Fig. 2-1).
- Insert the tip of a flat blade screwdriver into
the notch above the fuse drawer to release it.
- Remove the old fuses.
- Replace the old fuses with fuses of the same
type and rating.
- Push the fuse drawer back into its housing until
it clicks to indicate the correct position.
- Plug the power cord into the receptacle (Fig.
2-1).
- Plug the power cord into the electrical supply.
Note : The device also has an internal fuse not
accessible to the user.
Contact SATELEC after-sales service (see chapter
2 - Repairs).
All the information necessary for the repair of
faulty components is made available by SATELEC
to the technical personnel of the SATELEC-
approved dealer network who carry out the work.
12. 4 OPERATION FAULTS
Refer to the tables on the next page.
21
Fault detected Possible causes Solutions
Device does not operate
(LCD screen off)
Power cord not plugged in properly.
- Check the electric socket.
- Return to SATELEC after-sales.
Power switch in position O. Place the power switch in position I.
No power voltage. Call an electrician.
Power receptacle fuse(s) blown. Replace the power receptacle fuses.
Internal fuse blown. Return to SATELEC® after-sales.
Device does not operate
(LCD screen on)
Transmission fault.
- Switch the device off then on again.
- Return to SATELEC after-sales.
Torque fault
Thermal cut-out. Allow the micro-motor to cool down.
Incorrect torque adjustment.
Adjust the torque in accordance with good
dental practice.
Wrong contra-angle.
- Change the contra-angle.
- Return to SATELEC® after-sales.