______________________________________________________________________
TRANSITION MODULE: MODEL TRANS-C200
______________________________________________________________________
Type: Transition Module For ACPC8625 Boards
The TRANS-C200 transition module plugs into the rear backplane directly behind the carrier board. The field I/O
connections are made through the backplane to J4 and J5 connectors of the carrier board and then routed to four
SCSI-2 connectors on the transition module (marked IP module slots “A through D”) for rear exit from the card
cage. It is available for use in CompactPCI bus card cages which provide rear exit for I/O connections via
transition modules (transition modules can only be used in card cages specifically designed for them). It is a
double-height (6U), single-slot module with front panel hardware adhering to the CompactPCI mechanical
dimensions and IEEE Standard (1101.11-1998), with a printed circuit board depth of 80mm, which is a standard
transition module depth. The transition module connects to Acromag Termination Panel (Model 5025-552) using
SCSI-2 to Flat Ribbon Cable, Shielded (Model 5028-187) to the rear of the card cage, and to ACPC8625 boards
within the card cage
.
Application........................................................... To repeat field I/O signals of IP modules A through D for rear
exit from CompactPCI card cages.
Schematic and Physical Attributes...................... See Drawing 4501-791 (Over).
Electrical Specifications....................................... 30 VAC per UL and CSA (SCSI-2 connector spec.’s).
1 Amp maximum at 50% energized (SCSI-2 connector spec.’s).
Field Wiring.......................................................... Four SCSI-2, 50-pin female connectors (AMP 787082-5 or
equivalent) employing latch blocks and 30 micron gold in the
mating area (per MIL-G-45204, Type II, Grade C). Connects to
Acromag termination panel 5025-552 from the rear of the card
cage via round shielded cable (Model 5028-187).
Connections to ACPC8625...................................Connections are made though the PC board connectors J4
(110 signals, female right angle with upper ground shield-keyed)
and J5 (110 signals, female right angle with upper ground shield).
The transition module plugs directly behind the ACPC8625 board
into the CompactPCI bus backplane within the card cage system.
Mounting.............................................................. Transition module is inserted into a 6U-size, 80 mm width slot at
the rear of the CompactPCI bus card cage.
(Directly behind ACPC8625 board)
Printed Circuit Board........................................... Eight-layer, military-grade FR-4 epoxy glass circuit board, 0.063
inches thick.
Operating Temperature....................................... -40
°
C to +85
°
C.
Storage Temperature.......................................... -40
°
C to +85
°
C.
Shipping Weight.................................................. 1.25 pounds (0.6Kg) packed.
ACROMAG INCORPORATED
30765 South Wixom Road
P.O. BOX 437
Wixom, MI 48393-7037 U.S.A.
Tel: (248) 624-1541
Fax: (248) 624-9234
Copyright 1999 Acromag, Inc., Printed in USA
Data and specifications subject to change without notice
8500-623-B00D012
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
