ACO FUNKI Egebjerg MASTER Chain, Руководство пользователя

Страница: 9 / 24

Page 9 09-11-2018 · ACO FUNKI · Tlf. 97119600 · www.acofunki.com
FEEDING SYSTEM MASTER CHAIN
®
Drive unit
The optimum location of the drive unit is between the last feed outlet and the loading hopper. See rotating
direction on the illustration.
The drive unit may be installed on the floor, raised above the floor on adjustable legs (4-20 cm), or on the wall
using shelf brackets.
Feed pipes
The feed pipes are galvanised on the inside and outside. Inside the pipes is a little welding seam that must face
upwards when installing the pipes. This prevents unnecessary wear of the carriers on the feed wire or feed chain.
If required, shorten the pipes using a hacksaw or an angle grinder. Saw the pipes at a right angle, allowing for a
tight connection in the splicing sleeves. Grind the pipes on the inside and the outside, and remove any chips from
the pipes before installation.
The feed pipes must be supported every 3 metres, and attach to the ceiling, wall or a post using fittings. The
pipes must be fixed tightly so that it is not possible move them horizontally or vertically. It is important not to
force or bend the feed pipes around obstacles. Use a guide to check whether the piping is straight. If the feed
pipes are not mounted correctly, the carriers are subjected to unnecessary wear on the inside of the pipes,
causing damage to both pipes and carriers.
If the feed pipes are lead from a warm pig barn outdoors or through a non-insulated room, we recommend the
pipes to be isolated through the cold area to prevent the feed from coating inside the pipes as a result of
condensation.
4-20 cm.
Max. 3 meter.
Welding
Avoid edges that the carriers may hit
Rotating direction Rotating direction