ACO FUNKI Egebjerg MASTER Chain, Руководство пользователя

Страница: 8 / 24

09-11-2018 · ACO FUNKI · Tlf. 97119600 · www.acofunki.com Page 8
MASTER CHAIN
®
FEEDING SYSTEM
Assembly
Loading hopper
Place the loading hopper below the silo. The station may be attached directly to the silo using bolts or attached via
a funnel installed on top of the loading hopper.
The loading hopper is supplied with or without gate. If the silo does not have a gate we recommend you select a
loading hopper with a gate.
If you use a funnel and your silo has a gate, the top edge of the funnel must be lower than the silo gate, allowing
it to open freely.
In outdoor installations we recommend the loading hopper to be protected with a cover to prevent water
percolation.
Attach the loading hopper directly to the floor using coach screws or mount on adjupig barn legs to adapt the
height to the silo.
Mount the inspection pipe after the outlet pipe on the loading hopper using a splicing sleeve. Place the inspection
pipe so that the oblong hole is horizontal, and covered by the slotted plastic tube. Attach the plastic tube to the
inspection pipe using two clamps.
The inspection pipe allows the user to see how full the feed pipe is, thus checking the adjustment of the loading
hopper.
Adjustment
The loading hopper is fitted with a motor that drives a horizontally rotating arm via an axle. The rotation of the
arm causes continuous administering of feed to the feeding system to occur, thus preventing overload and
blocking. The feed quantity may be adjusted using a turnable dosing gate.
Considering the load and operating reliability of the system, we recommend the feed quantity to be set so that the
feed pipe is approximately half full. The feed pipe must never be more than two thirds full.
Dosing Gate
Rotating direction